The correction values for this device are: The pressure sensing range on these devices are fixed. OUTDOOR TEMPERATURE & HUMIDITY SENSORįor more information, see the data sheet of the device: Download. OUTDOOR TEMPERATURE SENSORįor more information & DIP switch settings, see the data sheet of the device: Download. Input Value 1įor more information, see the data sheet of the device: Download. Input Value 1ĬO2 measuring range is from 0 to 2000 ppm. The temperature, humidity and CO2 range on this device are fixed. INDOOR TEMPERATURE, HUMIDITY & CO2 SENSOR Humidity is from 0 to 100% relative humidity. The temperature and humidity range on this device is fixed. Inside the device, the DIP switches 1, 2, 3 & 4 define the temperature range. The correction values would be: Switch 1įor more information & DIP switch settings, see the data sheet of the device: Download. The sensor is supplied with the default measuring range set from -30☌ to 70☌. Temperature range is adjustable using DIP switches from -50☌ to 200☌. Inside the device, the DIP switches 8, 9 & 10 define the brightness range. The correction values would be: Switch 8įor more information & DIP switch settings, see the data sheet of the device: Download. The sensor is supplied with the default measuring range set from 0 to 100 lux. ![]() The signal is now adjusted in this linear graph:īrightness is adjustable using DIP switches from 0 to 100,000 lux. This is done in the properties of the analogue input, so click on the input and look down to the Correction section.įor this sensor you would put the following values in the correction as displayed in the screenshot. You can scale this in the software so that the 0-10V signal is displaying the temperature range, not the voltage. The analogue input however provides a signal from 0-10V. The sensor used in this example has a measuring range of -30☌ to 70☌. For example, a temperature sensor connected to an analogue input. This makes it possible to scale and also correct analogue inputs and outputs. Information on how to correct measured values INTRODUCTION TO CORRECTIONĪll analogue inputs and outputs in the Loxone Config have got a correction section in their properties.
0 Comments
Leave a Reply. |